BigBlue Combo Pack: AL450NM-II Tail & AL1300NP & Easy Clip Rainbow

Lumens measure the total light output, but they say nothing about how that light is shaped, so a tight narrow beam can look far brighter at distance than a higher-lumen wide beam. Beam angle, color temperature, and water clarity affect what you actually see as much as the lumen figure does. Use lumens to compare lights of a similar beam type rather than as a single score of quality.

A primary light is your main light, usually brighter, larger, and with a longer burn time, while a backup is a small, simple light carried in case the primary fails. Any dive where you need a light to exit safely, such as a night dive, calls for carrying at least one backup. Backups are chosen for reliability and simplicity rather than for maximum output.

Burn time and brightness trade directly against each other, so the same battery run at a lower power setting lasts substantially longer. Manufacturers usually quote burn time at each power level, and many lights automatically step down output as the battery drains or the head heats up. Treat quoted figures as fresh-battery, ideal-condition numbers and plan for more burn time than your dive actually needs.

The o-rings sealing the battery compartment are what keep the light from flooding, so inspect them for grit, hair, and nicks every time you open it, and wipe the sealing surfaces clean. Lubricate lightly with the grease type the manufacturer specifies, using a thin film rather than a heavy coat, because excess grease attracts sand. Replace o-rings when they look flattened, cracked, or dry, and do not over-tighten the cap in the hope of sealing a bad o-ring.

Lithium batteries are subject to airline and regulatory limits that vary by cell chemistry, watt-hour rating, and whether the cells are installed or loose. As a general rule lithium cells travel in carry-on baggage rather than checked baggage, with terminals protected against short circuit, but you must confirm your airline's current policy and any local rules before you fly. Carrying the manufacturer's battery specification sheet helps if you are questioned at screening.

Rinse it in fresh water after each dive day and work the switch while it is submerged so salt does not crystallize inside it, then dry it before opening. For storage, remove or charge the batteries as the manual directs, and leave the cap loose so the o-ring does not take a permanent set. Never store a light with corroded or leaking cells inside it.

Test it briefly as part of your pre-dive check, but do not leave a powerful light running in air, because many are designed to shed heat into the water and can overheat on the surface. Check the manual, as some lights have thermal protection that dims or shuts them down when they are dry. Testing before you gear up is far better than discovering a dead light at depth.

Each light uses a different power source. The AL1300NP primary runs on a rechargeable 18650 Li-Ion battery, which is included along with a charger that takes 3 to 4 hours for a full charge. The AL450NT-II backup uses 3x AAA batteries. The Easy Clip marker light uses 2x CR2032 coin cells, and two are included in the box.

All three lights in the pack are tested to a maximum depth of 100 meters. The AL1300NP primary and AL450NT-II backup both use anodized aluminum alloy housings, and the pack ships with spare O-rings and silicone lubricant so you can keep the battery compartment seals in good condition between dives.

The Multi-Color Easy Clip marker light produces six colors: red, green, blue, purple, orange and yellow, and each color also has a flash mode. It runs up to 24 hours on 2x CR2032 coin cell batteries and clips onto mask straps, belts and similar attachment points so your buddy can identify you underwater.

The AL1300NP delivers 1300 lumens at its highest level through a narrow 10 degree beam at 6500K cool white. A push-button switch steps output through four levels down to 130 lumens, with quoted burn times of 2 hours at level IV, 4 hours at level III, 8 hours at level II and 20 hours at level I. A color-coded indicator shows battery status.