Aqualung 3mm Superzip Dive Boot Black / Blue

As a general rule, thicker neoprene insulates more, so colder water pushes you toward thicker accessories, but fit, dive length, and personal cold tolerance matter as much as the millimeter number. Divers commonly lose a great deal of heat through the head, so a hood is often the highest-value warmth upgrade for the money. Remember that every added piece of neoprene also adds buoyancy you will need to account for.

Boots should fit like a snug athletic shoe, with no heel lift and no crushed toes; a little water inside is normal, a sloshing pocket is not. Try them on with the socks you would actually dive, and remember your fin foot pocket has to accommodate the boot. Hard-sole boots protect on rocky shore entries, while soft-sole boots are lighter and pack smaller for boat and travel diving.

Gloves should be snug across the palm with fingertips reaching the ends without bunching, since trapped air and loose fingertips destroy dexterity. Thicker gloves are warmer but make buckles, clips, and inflator buttons harder to operate, so choose the thinnest glove that keeps you comfortable in your conditions. Try working a clip or buckle while wearing them before you commit.

A hood should seal around the face and neck without restricting your throat or jaw, and lie flat on your head without pulling the mask strap out of position. A loose hood flushes cold water continuously, while an overly tight one is distracting and uncomfortable. Many hoods have a vent to release air trapped during descent, so check yours and burp out any trapped air before you go down.

New neoprene compresses and relaxes with use, so a boot, glove, or hood that feels firm out of the packaging usually settles slightly after a few dives. It should still be snug afterward rather than loose, because neoprene that stretches into a loose fit was probably oversized to begin with. Buy for a snug fit when new, but never for a fit that restricts circulation or breathing.

Yes, because every piece of neoprene you add is buoyancy, and a hood, boots, and thick gloves together can shift your weighting noticeably. Do a proper buoyancy check any time you change your exposure protection rather than assuming your usual weight still works. The weight-check procedure is covered in your training, and a dive professional can help you re-do it.

Rinse them inside and out in fresh water after every dive day, since they hold sweat and salt more than any other gear, and dry them fully inside-out before packing. Dry them out of direct sunlight and never on a heater, because heat hardens neoprene and weakens glued seams. Store them dry and unfolded, as damp neoprene sealed in a bag is how gear picks up a permanent smell.

This boot is listed in the Black/Blue colorway in sizes 03, 04, 05, 06, 07, 08, 09, 10, 11, 12, 13 and 14. Each size is a separate stock number, so choose your size on the product page. If you are between sizes or unsure how the boot will sit in your fin foot pocket, call or chat with us before ordering.

The 3mm version is aimed at warm and temperate water, where you want foot protection and a little insulation without extra bulk. The Superzip line is also built in 5mm and 7mm neoprene for colder conditions. Remember that a thicker boot needs more room in an open-heel fin foot pocket, so match thickness to both your water temperature and your fins.

The Superzip uses a heavy-duty, non-corrosive #10 YKK toothed zipper, chosen to resist wear and corrosion in dive use. A backing gusset sits behind the zipper line to ease entry and reduce water flow through the teeth. As with any neoprene accessory, rinse the boot inside and out in fresh water after each dive day and dry it fully before storage.

Yes. The 8mm treaded sole protects against punctures, stings and slips on boat decks and shore entries. Toe and heel reinforcement also resists abrasion from fin straps and fin foot pockets, the areas that usually wear first on a dive boot.