Mares Mission Puck 2 Dive Computer-AS-ONE

A dive computer tracks the actual depth and time profile you have dived and the tissue loading that follows from it, which is personal to you. A rented computer has no record of your recent diving, and swapping models each trip means relearning the display and menus when you should be focused on the dive. Owning one you know well is a genuine safety and comfort improvement.

No. A computer only tracks the profile of the diver actually wearing it, and even buddies who stay together do not follow identical depth and time profiles. Every diver needs their own computer, and passing one between divers or between dives is unsafe.

Conservatism settings make the computer's calculations more cautious, shortening allowed bottom times and adding margin beyond the base algorithm. Divers commonly add conservatism for factors such as cold, hard work, fatigue, or repetitive multi-day diving. How and when to adjust it is covered by your training and your computer's manual, so set it before you get in the water and follow what your computer tells you during the dive.

Broadly there are two types: user-replaceable batteries, often a coin cell that you or a shop swap along with resealing an o-ring, and sealed rechargeable batteries that charge from a cable or dock. Neither is universally better, as replaceable cells are convenient on remote trips while rechargeables avoid ever opening the case. Follow the manual exactly for any battery change, because an improperly seated o-ring or case is the usual cause of a flooded computer.

Yes, both change the picture, and both are governed by your training agency's guidance and your computer's instructions rather than any casual rule of thumb. Many computers have an altitude setting that must be configured before diving at elevation, and most display a no-fly or surface-interval countdown after a dive. Follow your computer and your training, and ask a dive professional or a dive-medicine specialist if you are unsure.

Rinse it in fresh water after every dive day, paying attention to the buttons and around any sensor openings where salt crystals form, and let it dry fully before storing. Keep it out of prolonged direct sun and extreme heat, and avoid pressing buttons while sand is on the case. Inspect the strap or bungee often, because a failed strap loses far more computers than a failed computer does.

A wrist computer is worn like a watch and read by raising your arm, while a console computer sits at the end of a hose with your other gauges. Air integration means the computer also displays cylinder pressure, either through a hose or from a wireless transmitter on the first stage, and often estimates remaining gas time. All of them run a decompression algorithm, so the real difference is where you read the information and how much of it you get.

The Mission Puck 2 supports air and nitrox with oxygen settings from 21% to 50% EAN, which covers the standard recreational nitrox blends such as EAN32 and EAN36. The computer supports air and nitrox settings from 21% to 50% EAN, operated through its single-button interface. Follow your training agency's procedures for analyzing and logging the mix in your cylinder.

The Mission Puck 2 uses a CR2450 coin cell that is user replaceable, with a stated life of roughly 200 to 300 dives. That makes it practical for travel, since you can carry a spare cell rather than depend on a charger. As with any battery swap, the seal and o-ring must be cleaned and seated correctly, so many divers have a dive shop handle the change.

The logbook holds 35 hours of dive profile data recorded at 20-second intervals, and the memory capacity is listed at 36 hours. During the dive the profile sampling rate is 5 seconds. It also includes a residual nitrogen reset function, and the ascent-rate indicator gives you visual feedback on your rate of ascent while you are still in the water.

It is built as a console unit around a chrome-plated brass submersible pressure gauge housing, so it attaches to your regulator's high-pressure hose and is read by looking at the gauge rather than at your wrist. Multiple lanyard attachment points let you clip or route the console to suit your BCD and hose routing. Contact us at 888-701-4017 if you want to confirm your setup.